The GO! Angel die contains the main angel body (7" tall) and two separate wings (right and left) for versatility in wing placement. This popular classic shape can be used for many types of projects such as quilts, wall hangings, holiday-themed, as well as, everyday angelic projects.
AQ Cutting Mat Required:Â GO! Cutting Mat, 6 in. x 12 in. 2 Pack (15.2 cm x 30.4 cm) Item 255112
How to Die Cut Angel Shapes:
Apply fusible web product to the wrong side of the fabric, following manufacturerâ€™s instructions, before cutting for fusible appliquÃ©.Â Â
- Angel:Â Cut and fuse 4" x 7 1/4" rectangles. Cut 10 angels across the width of fabric. One yard of 40" wide fabric cuts 40 angels.Â
- Wings:Â Cut and fuse 4" x 5 1/2" rectangles. Cut 14 wing across the width of fabric. One yard of 40" wide fabric cuts 126 wings.
Why Quilters Love the GO! Angel Die:Â
- The GO! Angel die contains the main angel body (7" tall) and two separate wings (right and left) for versatility in wing placement. This popular classic shape can be used for many types of projects such as quilts, wall hangings, table runners, pillows, holiday-themed, as well as, everyday angelic projects.Â
- No templates required! The GO! Angel die includes applique shapes that are typically difficult to cut by hand.Â
- Quickly and easily cut four of each pre-fused applique shape in one pass thru the cutter (fusible counts as one half layer of fabric).Â
- Cut angel shapes out of a variety of fabrics: cotton, batiks, wool, felt, flannel, fleece, CuddleÂ® fabrics and more!Â
- A great way to use up scraps.Â
- Free pattern downloads available to get you started.Â
- Layer Cake and Fat Quarter-friendly.
- Cut so much more fabric in less time.Â
- Get accurate cuts every time -- No slipping rulers or mistakes
- Easiest to use -- Simply place die on cutter, then fabric and cutting mat on top
- Save fabric with Two Tone Foam -- Get more out of your fabric by placing it only over the shape you want to cut.Â
- Safe to use -- No blades come anywhere near your fingers
- With some fabrics, after cutting, a thread or two will remain where die blades meet. Snip threads with scissors.Â
- Blades on some dies are positioned at an angle.Â Align fabric to edge of shape, not edge of die board.Â
- Use good quality fabric to reduce fabric stretch.Â
- It's always a good idea to test cut one shape before cutting many shapes to ensure fabric orientation is correct.Â